Minn Kota ultrex

[Slick Rick]

Has anyone ever installed rubber pegs on the bottom of your Ultrex foot pedal to raise it up in the recessed tray for easier access to the buttons on the foot pedal, with shoes on its hard to hit the rear buttons. Pictures would be great if anyone has figured it out.

[06 SB]

I have not done it but you could also use a poly cutting board configured to match your TM pedal area. Use longer screws and run them through the cutting board and down into your current screw holes.

[jerzia]

Not on an Ultrex, but did it for a Motorguide, same principle. Depending if you have your pedal screwed down in the well, what I did was put nylon spacers from a hardware store, (you can use any material) and ran the screws through them when mounting. I raised my pedal up an inch and it worked fine, but again you can do any height. Of course you will need longer screws.

[FrancoCialone]

You could try rubber furniture feet, quiet, won't move around, but might wear out or have to be replaced, I used these under my old Motorguide TM foot pedal, but the pedal was just sitting on carpet, never moved around.