I have a CMC 10 inch hydraulic jackplate that has a bent part I need to fix it. The 10 inch side plate on the port side(passenger side) mounted to the boat is bent where the upper slide bolt with roller is mounted. Does anyone have a broken 10 inch hydraulic plate that they could sell that part off of?
Richard aka Kllr Bee
Last edited by kllr bee; 07-04-2023 at 01:59 AM. Reason: Spelling
Still looking for part.
Richard aka Kllr Bee
Post a picture of what you need. I will look and see if i have one.
Port side 10 inch cmc powerlift. See how top bolt is leaning back toward motor. Bolt is not bent.
Richard aka Kllr Bee
Last edited by kllr bee; 07-15-2023 at 04:08 AM. Reason: Add info
So you need the piece that slides?
I need the part that mounts to the boat and has bolts that go in the rollers that the slide goes on. It would be for the passenger(port) side.
Richard aka Kllr Bee
Surely someone has a 10 inch cmc powerlift that died that has good 10 inch boat mounts.
Richard aka Kllr Bee
How about a complete cmc hydraulic10 inch jackplate?
Richard aka Kllr Bee
How did it become bent?
Allison XB-21 ProSport
Yamaha 250 SHO
Croxton Razor 4XL
It's the bolt on port side leaning back toward motor. Bolt is not bent. Threads have twisted in bracket. It may be because I run kinda hard because it is on a 21xd Comp Bullet that had a 300xs Merc on it for 6 years. Just noticed it when I was studying my new 300R merc!!����
Richard aka Kllr Bee
I had one that i took off a 89 395 VS Ranger , I will take a look and see if I still have it.Originally Posted by kllr bee
Thanks.
Richard aka Kllr Bee
Reply With Quote