Results 1 to 5 of 5
  1. #1
    Member kcg202champ's Avatar
    Join Date
    Apr 2017
    Location
    Salem, Virginia
    Posts
    956

    Manual bilge pump lights

    Hello fellerz... i have a '17 520C currently... my question is, i went night fishn a couple nights ago and noticed that the manual bilge pump button on the console was blinking on the leftside but the bow button was blinking on the right side... i pushed both a couple times and got the bilge to turn ON (even though i didn't need it to pump anything out) but they blinked ALL night i was out on the water (6 hrs) .... what do i need to do to make them go off or do i need to check the wiring on the bilge? Nothing is blocking it cause i did pump out some water after trailering it after done fishing.
    Any info would be much appreciated

  2. Member
    Join Date
    Apr 2014
    Location
    Burlington, Ontario
    Posts
    392
    #2
    I havent had this happen but i'd check the wiring to the switches and the bilge. i'd also look at the fuse just in case. sounds like it might be a loose connection.
    Wishin I Was Fishin...

  3. Member kcg202champ's Avatar
    Join Date
    Apr 2017
    Location
    Salem, Virginia
    Posts
    956
    #3
    Good info. Will check that this upcoming weekend

    Anymore info?

  4. Member
    Join Date
    Apr 2014
    Location
    Burlington, Ontario
    Posts
    392
    #4
    It could be battery related, most likely not but, make sure the battery is fully charged, connections are good and clean, if you can't figure it out, you could remove the fuse until you get it fixed, just keep an eye on the bildge and have that fuse handy in case you need to plug it in and use the bildge. Other than that check the wiring. Good luck��
    Wishin I Was Fishin...

  5. Member
    Join Date
    Jul 2017
    Location
    Nederland,TX
    Posts
    6
    #5
    Hold the blinking button down for 5 seconds or more and it will reset.