Prop won’t fit

[timg185]

I have a 25 pitch 4 blade fury that I ran on a 2019 Mercury pro xs 4 stroke. I sold that boat and now own a 2021 200hp mercury Pro xs. My 4 blade fury does not fit my 200hp. So I’m wondering what engines this prop will fit. Does anyone know?

[21XDC]

Yes, it will fit. You must not be using the correct hub kit.

[timg185]

Gonna have to check again. But the hub kit did not appear to be interchangeable . The brass adapter in the center of the hub seemed to be permanent. Maybe it’s just stuck . Thanks you for the help!

[Pulsare2020]

I have a 25 pitch 4 blade fury that I ran on a 2019 Mercury pro xs 4 stroke. I sold that boat and now own a 2021 200hp mercury Pro xs. My 4 blade fury does not fit my 200hp. So I’m wondering what engines this prop will fit. Does anyone know?

Does the new 200HP ProXS have a 1.25" prop shaft and the old engine was perhaps a 150 HP which may have had the smaller diameter prop shaft? If that was the case, you need to buy a new hub for a 1.25" prop shaft and that hub should fit into your Fury prop.

[Frostypuke]

A socket and a hammer and a few good kwhacks should get it out. Be sure to grease the new hub for easier removal. There’s plenty of YouTube videos

[krindgen]

Take the back piece of the hub, the little splined part on the back of the prop, take it out, rotate it in the hub like a quarter turn. Now it's sticking above the back of the prop, smack it with a dead blow hammer. You'll get the hub out. Mine would fool yah thinking it's permanent.