Results 1 to 2 of 2
  1. 05-24-2011, 06:36 AM #1
    Swammp Thang
    Swammp Thang is offline
    Member
    Join Date
    Mar 2011
    Location
    Seneca
    Posts
    154

    Adjusting Idle Speed of 200 Venom

    '95 Johnson 200 Venom Is Idling fast when on the hose and in the water. What is the proper technical way to go about adjusting the idle speed?

    Reply With Quote Reply With Quote
  2. ChampioNman
    ChampioNman is offline
    SC Club Moderator ChampioNman's Avatar
    Join Date
    May 2004
    Location
    Crawfordville, FL/Lake Hartwell, SC
    Posts
    72,186
    #2 05-24-2011, 07:27 AM

    Re: Adjusting Idle Speed of 200 Venom (DonkeyKong)

    Unhook throttle cable from motor. Make sure all butterflies are closed. Mark TDC on flywheel, start motor and get to temp. Connect timing light to #1 plug wire, shoot timing wheel. Adjust screw on timing arm that hooks to the timer base.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Adjusting Idle on 3.1 ?
    By BttrBn in forum Yamaha Motors
    Replies: 12
    Last Post: 02-25-2012, 05:13 AM
  2. adjusting low end idle adjustment screws
    By depfreeman450 in forum Evinrude/Johnson Motors
    Replies: 5
    Last Post: 05-11-2009, 02:37 PM
  3. Motor Issue adjusting the IDLE
    By Blacktri99 in forum Evinrude/Johnson Motors
    Replies: 6
    Last Post: 09-17-2007, 03:02 PM
  4. Adjusting idle on ox66
    By kensafishin in forum Yamaha Motors
    Replies: 2
    Last Post: 09-04-2007, 02:36 PM
  5. Adjusting Idle RPM's...
    By usamarshal in forum Evinrude/Johnson Motors
    Replies: 5
    Last Post: 10-24-2006, 07:19 AM