1990 Johnson 200, prop shaft has about 1/8" fore-aft play. To me that seems excessive, but I can't find any information on this in the factory service manual.
thanks
1990 Johnson 200, prop shaft has about 1/8" fore-aft play. To me that seems excessive, but I can't find any information on this in the factory service manual.
thanks
1979 Checkmate Eluder
rebuild thread http://forums.iboats.com/boat-restor...er-541058.html
1993 Rude 175
1990 Johnson GT-200 - died
Where NOT to buy an engine in Savannah, GA http://forums.iboats.com/showthread.php?t=537238
That's about normal for a standard rotation gearcase
-----
A Technical troubleshooter possessing more tools than talent !
1/8" is most excessive. You have the older 1-3/16" propshaft, which required no spacer ring to wear out. I would look into this A.S.A.P. All the cases have @ .070 at maximum endplay as a rule of thumb. Make sure the 4 bolts holding the carrier in place are tight.
Reply With Quote