I posted on 6/2/10 a question on jet sizes for a 93' motor but a 97' or 98' powerhead that had been installed. I never recieved any responses I was wondering if my question was not clear enough or I might have not posted properly? thanks Joe
I posted on 6/2/10 a question on jet sizes for a 93' motor but a 97' or 98' powerhead that had been installed. I never recieved any responses I was wondering if my question was not clear enough or I might have not posted properly? thanks Joe
Sometimes we get a little busy. Sorry. But to answer your question here is two things you can do. Remove one or two of the drain plugs and inspect the carb end on them if they are smooth order 6 new drain plugs. the new plugs have a "tit" on the end of them to keep the HS orifices in place. Then on your #2 carb HS orifice look at the stamp on the side, if it is a 64D order a 66D install it in the #2 bowl. the increase in size will help cool the #2 cylinder. Hope this helps.
Thank you ChampioNman I know your very busy and active on this board and I respect and appreciate your advise not only to me but all your other helpful posts. Fishinjoe
Reply With Quote