My control box is original from 1991 (was paired with a 1990 150hp) Surface mount box. Never any issues. Last week, it would not crank until I wiggled the handle. Pulling it back and motor fired normally. Yesterday I had to do it twice. So I have few questions:

1. Is a replacement switch available, and is it hard to change?

2. Should I leave it alone and just wiggle it when needed?

3. If I'm out and wiggling will not help, is there a way to bypass it to get me back to the ramp?

4. I have another control box in garage, but don't have a key for it. Is there a way to look up and get a replacement key for this extra box?

Thanks,