Hello, I have recently installed 2 Solix units in my boat which are networked via NEMA 2000 gateway. I also installed a EMU1 Engine data gateway connected to the NEMA 2000 network. So far I was able to pull RPMs, Fuel Level, and Oil Pressure to display correctly on the both Solix unit dash display. I am however struggling with Engine temperature. On the dash view there is no temperature reading at all however, in the Engine Data side panel it reads perfectly. I am stumped where to find this data input for the temperature in the Solix unit. In the source data I use ENGINE(1) which pulls all the inputs I have set up in the EMU1. My Instance is 0 which applies to all inputs. I Have tried ENGINE(2) and ENGINE(3) but to no avail. I have the EMU1 reader which gives a live view of the inputs and I can see the engine temperature there as well. It is only the Dash VIEW that I can not get this to display.

Anyone have experience with this kind of setup?

Thanks