Results 1 to 2 of 2
  1. 07-03-2007, 07:52 AM #1
    joevandal95
    joevandal95 is offline
    Member
    Join Date
    Jan 2007
    Location
    Nampa, ID
    Posts
    1,393

    How hard is it to add a water pressure gauge to E-Tec 150

    I just repowered my boat with an E-TEC 150 and would like to add a jackplate, but first I need a water pressure gauge. I have a hole in the dash available for it but I am not sure about the wiring. Do I need to get a wiring harness or is it already there and I just need to get a gauge?
    2013 Nitro Z8
    2013 Mercury 250 Pro XS
    Reply With Quote Reply With Quote
  2. joevandal95
    joevandal95 is offline
    Member
    Join Date
    Jan 2007
    Location
    Nampa, ID
    Posts
    1,393
    #2 07-03-2007, 08:13 AM

    Re: How hard is it to add a water pressure gauge to E-Tec 150 (joevandal95)

    Nevermind. I found the answer.
    2013 Nitro Z8
    2013 Mercury 250 Pro XS
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Water Pressure gauge goes??
    By Dawnpatrol in forum Evinrude/Johnson Motors
    Replies: 14
    Last Post: 10-20-2011, 06:56 PM
  2. WATER PRESSURE GAUGE
    By j250trxr in forum Blazer Boats
    Replies: 1
    Last Post: 06-26-2011, 03:31 PM
  3. Water Pressure Gauge...Hard to change?
    By beckleybassfanatic in forum Stratos/Javelin Boats
    Replies: 2
    Last Post: 11-18-2008, 03:04 PM
  4. water pressure gauge?
    By rayzrbck in forum Skeeter Boats
    Replies: 2
    Last Post: 03-04-2008, 10:40 AM
  5. water pressure gauge / temp gauge
    By bubbagump6666 in forum Evinrude/Johnson Motors
    Replies: 3
    Last Post: 01-09-2008, 02:36 AM