Results 1 to 4 of 4

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 01-31-2019, 10:02 AM #1
    Frank Moritz
    Frank Moritz is offline
    Member
    Join Date
    May 2011
    Location
    Mooresville
    Posts
    155

    Won’t go all the way into gear

    My 2000 225 HO won’t stay in fwd gear. Keeps popping it out and “clunking” real hard. I tried the wheel adjustment on the side of the motor but it didn’t help. It locks into reverse just fine. I can’t even get it to lock on the trailer while holding the lever fwd. Any ideas? Thank you.
    Reply With Quote Reply With Quote
  2. Frank Moritz
    Frank Moritz is offline
    Member
    Join Date
    May 2011
    Location
    Mooresville
    Posts
    155
    #2 01-31-2019, 10:03 AM
    Also, if I do get it to lock into forward gear, it works fine. Is it an adjustment or cable maybe. Thank you
    Reply With Quote Reply With Quote
  3. ChampioNman
    ChampioNman is offline
    SC Club Moderator ChampioNman's Avatar
    Join Date
    May 2004
    Location
    Crawfordville, FL/Lake Hartwell, SC
    Posts
    72,111
    #3 01-31-2019, 05:11 PM
    Frank has the lower been off before this started, like for a water pump job? If so did the rod get adjusted to spec 21 15/16" in neutral to the eye on the shift rod . If not, sounds like the clutch dog is on its way out.
    Reply With Quote Reply With Quote
  4. Frank Moritz
    Frank Moritz is offline
    Member
    Join Date
    May 2011
    Location
    Mooresville
    Posts
    155
    #4 01-31-2019, 06:16 PM
    It wasn’t taken off. It’s been getting worse as the summer went on. I usually was able to put it into reverse and it would work but it started to not work and I tried to adjust it and i thought that worked till I got on the lake. Tried to adjust it again thinking maybe I went the wrong way it it still isn’t locking in. If I hold the lever in fwd gear and kick the prop, it pushes it back against my pressure.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »