Hey guys, has anyone had a problem with their rear seat mount? Mine was loose and the screws would not tighten. It was a chore to remove the old screws and nuts because they were frozen and bent.

After removing the mount, I noticed that the top holes are too close to the outside wall so that a socket cannot fit around the nut. This would mean that the new nuts would never get tight enough. I am unable to access the top plate with a wrench.


A guy at BassPro Shops suggested using a wing nut so that the ears will keep the nut from turning and the screw will tighten.


This has worked ok so far. The 2nd option is to make a large washer to fit under the bottom plate and then tighten the nuts to against the washer. Any other ideas?

By the way, I tried calling Skeeter to ask this question and they asked me to first call the service department at the closest dealer. If they cannot help, then the dealer will call Skeeter.




Modified by Wormweight at 12:48 PM 2/8/2007