Trying do the brake fluid (flush) ,went to loosen the bleeds ,...seems like they are made of steel, not brass. A real PITA to loosen them . Sprayed some " Kroil" will that penetrate overnight hoping to get off tomorrow .
Trying do the brake fluid (flush) ,went to loosen the bleeds ,...seems like they are made of steel, not brass. A real PITA to loosen them . Sprayed some " Kroil" will that penetrate overnight hoping to get off tomorrow .
Be patient, you may have to spray them several times. Worst case scenario, get new calipers if they are old and rusted up. Living in Mass, the weather is brutal on cars, trailers etc!
Also look up speed bleeders. Made in USA and all stainless. I can flush and bleed my trailer in 5-7 minutes by myself. Purchase the tube and bag while your at it so as not to make a big mess
Respectfully,
Captain Rab
V1CO 1:27 But God has chosen the foolish things of the
world to put to shame the wise; and God has
chosen the weak things of the world to put to
shame the things which are mighty
Sea Foam Deep Creep is the best Penetrating oil out there. We use it at the shop.
i use small propane torch and heat them up, spray with penetrating spray, cool down. try again. repeat until they come loose
2022 z519 cup 225 merc 4s ser # 3B210484. 2--hds12 live units. 2 poles, atlas plate, ghost, hamby's, active target, merc digital gauges
2002 basscat pantera 3 (dad bought new) sold 8-2-22
2000 stratos 20 ss (bought new) 200 hp Rude ficht great boat/motor sold 11-21
pulled by a 2500HD Denali
proud dad of an ARMY Captain
MAGA
ASE/GM Master tech before tools
Removed 1, the second one is a PITA ! Sprayed Super Creep, used a torch. Will not budge! Might try an "easy out" bit. Not much room to work.
FINALLY got it out using a bolt remover with impact drill. Nobody has that size fitting in my neck of the woods. Waiting for email from Trailer Store regarding if they have them.
Put new bleeders on , started to bleed/ flush ,… not having any luck . Bleeders are open, one at a time ,… nothing coming out after pumping for an hour .
Probably find one on a used drum laying in a junkyard
Drum for what ? " Tried " to bleed/Flush,.. opened on at time ,...nothing coming out of bleeders.
Figured it out,... There is a leak in the brake line inside the same tube that trailer harness goes through. Seems like I am going to cut the wire harness ,remove the the metal tube to fix the leak . What else is next ?
Why do you have to cut the harness?
I don’t , was just over thinking it , like a lot of things . Just remove the leaky one , install a new setup from the master cylinder , to the brakes . Ordered a new kit .
Is there a need to use “plumber’s tape “when installing new brake line ?
Not that I have ever heard.
Thanks
Installed new fittings ,started flushing the lines . One fitting was leaking while doing the other side (the leaking fitting was in tight), would not stop leaking no matter how far I loosened or tightened.