I know this will sound stupid but I cannot locate the kill switch on this boat. The lanyard was in the boat when I bought it but I can not figure out where the kill switch is to attach it.
Also, can the passenger console be removed? If so, will it leave an ugly mess?
Thanks guys.
It should be the little red lever by the shifter.
Don Blume
2018 Ranger Z520C
2018 Mercury 250 Pro XS 2B525775 2-Stroke
Past Rigs
2008 Triton Tr186 with Mercury 175 Pro XS
2000 Ranger R73 with Mercury 125
1976 Basscat with 150 Mercury
Get on the floor and look under the shifter.
Thanks for the suggestions, but it is not under the shifter. The lanyard has a strange end that looks like a very small cup with a slot removed. It doesn't have a toggle switch like my last boat did?????
Anyone have this model?
You should find what looks like a small black button that is raised in the middle. The clip you are talking about, holds the button in the middle in the depressed position.
2017 Phoenix 920 ProXP, with Evinrude 250HO G2 and 8" Power Poles
You never said what kind of controls you had (Mercury,Evinrude,ect)?
Tournament-Fishing \"It\'s not a question of if you will be humbled but how many times\"
see if it slides up where the ignition key is.
I think if you depress the ignition key, like you were going to choke it, this will slide around it to hold it in.
I think it was originally part of the key switch...maybe. But the boat will crank without it in place and it does not seem to fit the key switch either pressed in or out. Could it be that the switch was removed? If anyone has this boat and motor I would really appreciate a picture...
I need to get it figured out before tourney time...
Turn ignition to on. Pull out on key. You should have a groove to slide it into with flat side toward you. Its the second picture on this address.
http://www.google.com/search?t...w#i=1
Modified by DaleHollar1 at 7:31 PM 2/1/2012
Donald
I told u wrong. I was back on my friends boat today. Put key in. Push on it and slide the kill switch over part of ignition switch you push in.
Donald
<table width="90%" cellspacing=0 cellpadding=0 align=center><tr><td>Quote, originally posted by mayaemer »</td></tr><tr><td class="quote"> But the boat will crank without it in place and it does not seem to fit the key switch either pressed in or out. Could it be that the switch was removed? If anyone has this boat and motor I would really appreciate a picture...
I need to get it figured out before tourney time...</td></tr></table>
That is whats known as a man overboard feature so if the dtiver is thrown out the passenger can move the boat over to pick him up. with the key pushed in the U shaped piece will fit over the piece that moves in and hold it down. With the key turned on and the clip removed the spring will turn the switch off. The clip fits with the small opening up and the large opening down.
Dan Burnette - Marietta, GA
Triton 18TRX - 200 HO G2
<table width="90%" cellspacing=0 cellpadding=0 align=center><tr><td>Quote, originally posted by fastr19 »</td></tr><tr><td class="quote">I think if you depress the ignition key, like you were going to choke it, this will slide around it to hold it in.</td></tr></table>
Must be some old controls because they have not used those type in years,There should be a black button that poushes and the kill switch slides over it.
This is what it should look like if it's for a Evinrude.
Reply With Quote
