Hull Composisition 96 389TE

[ernel]

Does anyone know if Javelins have an inner floatation material that would prevent the installation of a shoot through hull transducer? I am wanting to place a transducer in the bilge area to keep bottom contact at higher speeds.


Modified by ernel at 8:33 PM 3/19/2006

[lkhartwl]

the area you are asking about is fine for a thru the hull transducer just make sure that you get ALL the air bubbles out of the epoxy otherwise it will not read right. best place for placement is infront of drain hole in pad about 6" in front as not to block the drain. hope this helps some.

[ernel]

Thanks for the response. I would have really hated to get 'er glued down and it not work. They don't come back up as easy as they go down.