skeeter water pressure gauge

[boxcar basser]

my water pressure gauge is stuck on about 15 lbs how do you clean out line or tube to get this to work ... thanks ralph

[Lockon]

Not sure "cleaning" it will work. It sounds like what happened to mine...it was left in the boat by the previous owner and water froze in it...it was ruined. I had to buy a new one.

[Rodney Bledsoe]

Buy a new one

Ralph welcome to BBC

[Skeeter185]

<table width="90%" cellspacing=0 cellpadding=0 align=center><tr><td>Quote, originally posted by Lockon &raquo;</td></tr><tr><td class="quote">Not sure "cleaning" it will work. It sounds like what happened to mine...it was left in the boat by the previous owner and water froze in it...it was ruined. I had to buy a new one.</td></tr></table>

Yep its shot. Buy a new one or send it back to Faria if that's the brand of yours and they will fix it for $15.00 plus shipping.

[Lockon]

<table width="90%" cellspacing=0 cellpadding=0 align=center><tr><td>Quote, originally posted by Skeeter185 &raquo;</td></tr><tr><td class="quote">

Yep its shot. Buy a new one or send it back to Faria if that's the brand of yours and they will fix it for $15.00 plus shipping.</td></tr></table>

Really?? I have my old one on the shelf...might try having them fix me old one

[wildkat7]

<table width="90%" cellspacing=0 cellpadding=0 align=center><tr><td>Quote, originally posted by boxcar basser &raquo;</td></tr><tr><td class="quote"> my water pressure gauge is stuck on about 15 lbs how do you clean out line or tube to get this to work ... thanks ralph</td></tr></table>

It likely froze....mine "zeroes" at 15lbs and goes up from there due to not properly draining mine....

[dr. seuss]

mine is frozen up also..its a 3 in 1 gauge and is gonna cost me about 180 bones

[boxcar basser]

thanks guys ..ill take it out and sent it to them to see if they will fix it .if not where do i get one new

[Lockon]

<table width="90%" cellspacing=0 cellpadding=0 align=center><tr><td>Quote, originally posted by boxcar basser &raquo;</td></tr><tr><td class="quote">thanks guys ..ill take it out and sent it to them to see if they will fix it .if not where do i get one new </td></tr></table>

I got mine off Ebay

[Ranger391v]

If you've ran grass or into a sandbar, it could be clogged. But being that you're up north, I'd imagine froze/busted is more likely.

To answer your question ...... disconnect the hose from the back of the gauge, then disconnect the hose from the hose barb fitting on the block of the motor (located on the top starboard side on a 2.6L) ..... once disconnected from both ends, use compressed air to blow any crud out. I like to use a glass jar to catch the opposite end so I know for sure what came out.

Good Luck!