tzx200

[macinckirk]

I see you sold your 25t-1 are you going to get a 25 furry now??


Modified by macinckirk at 11:11 AM 11/5/2008

[tzx200]

Yep......I have another 25T1 also.......

[macinckirk]

let me know how it does on your sled when you get it dailed in, compared to the 25t-1 that is B&B

I'm thinking hard about getting 1 but I'm thinking about a 24pitch

[tzx200]

Jack the plate as high as it will go. The T1 will carry the load. Dont worry you will not lose water pressure with the plate all the way up. I have run mine with a hydraulic to 1.5" above pad.

[macinckirk]

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by tzx200 &raquo;</TD></TR><TR><TD CLASS="quote">Jack the plate as high as it will go. The T1 will carry the load. Dont worry you will not lose water pressure with the plate all the way up. I have run mine with a hydraulic to 1.5" above pad. </TD></TR></TABLE>

The T-1 does a great job with carrying the load but I'm just not getting the r's, 5500 up here on the wood, 5700 on elsinnor last week/fri 71. tenths and this monday could only get 72. tenths less fuel running the speed area, I can only see 5800 for a sec or 2 on a long run like at mead 73. tenths is the best I have seen

I have had the j/p all the way up allready and right now its down about .25 - .50" because I was thinking about moving my motor up a hole but after I started to do it myself I changed my mind (I was going to do it with a floor jack) when I had the motor dyno I should of paid the 100.00 to have it done then

I know this boat has more to give and its piss*ng me off

[tzx200]

Using the floor jack works, you only have to loosen the bolts for the slide area so it wont fall and then put the other 2 back in. Cant do that with a Merc.

[macinckirk]

Yea that was what I started to do but then I was worried that the top of the motor would move and trying to line up the top holes would be a b*tch I also have the wedge on my j/p for the 20I so its at a diff angle. So I lowered the front of the trailer to the floor and just got cold feet on doing it by myself

you know the only time I get worked up about it is when I come to this place If I was on big water more I guess I would of allready done something but you know how the lakes are here

But I do know down the road I'm going to buy a 2nd prop for this boat so thats why I'm thinking about it, the other 2 props I have will go with the 202zx when and if it ever sells

[tzx200]

Man, it must be noce to have 2 boats. I have the wedges to. Its not that hard, just make sure you loosen the top 2 only and remove the bottom ones and slide her on up!

[macinckirk]

Damit you made me go out and move that motor up 1 hole at 4:00am this morning
I ran the boat today on the wood and talked to Mark a few times, will have to see what it does down the hill now

[tzx200]

I used to be Anal like that, but finally said no more! Trust me you'll sleep better now knowing you did it!