Noticed yesterday on my '07 ZX225 that the passenger seat was alittle loose. Looks like I would need to take the 3 screws out of the bottom and then the seat would just slide upwards, to tighten the back bracket screws. Is this correct?
Noticed yesterday on my '07 ZX225 that the passenger seat was alittle loose. Looks like I would need to take the 3 screws out of the bottom and then the seat would just slide upwards, to tighten the back bracket screws. Is this correct?
Jason Ferrell
Virginia
2015 Skeeter ZX250
2015 Yamaha VMAX SHO 250
I just did mine, and the back screws weren't loose, but the aluminum brackets that the tongue slides in were kind of bent forward, so I gently tapped them back into place. not sure if yours will be set up the same, but either way I'm sure once you pull the seat backs up you'll find your problem.
Common Sense...so rare, it's kind of like a SUPER POWER!
Reply With Quote