A where the heck can I get one of these question.....

[RyanB]

I need am looking for the plate that covers the hole where bow mounted electronics (332, 135, etc) are mounted. I guess that is clear??? any suggestions

[gofish24]

in looking over the hundreds of posts about mounting a GPS puck, i saw one that said lowes or home depot have covers that will fit in the hole. i htink it was in the nuts/bolts deaprtment.

[MD 20i]

here is the one i always use. its at the bottom of the page.


http://www.theshadconnection.c...ge=16

[fishin couillon]

I have one like MD ZX225. I bought it at my local marine store. Check there first then look at other places. Would hate for you to spend $8 on shipping on something that cost $4 or so.

[RyanB]

I am needing a plate to cover the whole the actual unit (332) is in. This is the plate I need.
http://im1.shutterfly.com/proc...No2c2

[kk4iz]

you might have a plate made from uhmw or plexy glass

[kirbyv1]

I dont know if this will help.

http://cgi.ebay.com/ebaymotors...wItem

[Doug Vahrenberg]

I would ask your local Skeeter dealer. They had a plate that was installed when a graph was not used in the bow. If a dealer installed the graph they might have plate in the shop. They had two studs in the back If I remember correctly.

[RyanB]

Thanks Kirby, but that one is a little big.

I contacted a dealer and he has one but it is 2 hours away.

[kirbyv1]

why couldnt you trim it to fit

[tigerman]

Ryan,
I work at Palmetto Boat Center where you had your boat not too long ago and I can order one from skeeter if you would like me to. Let me know, the number is 864-269-6200, and my name is Ben. By the way how did your gelcoat repair go?

[RyanB]

Ben-I appreciate it but my boat is over near H-D Marine right now and all I have to do is swing in when I go pick up my boat and pick one up.