NEED HELP WITH RAKER PROP ON JOHNSON 150 FAST STRIKE

[DUP1014]

I bought a raker prop for a spare and wanted to try it but the thrust washer won't go all the way down on the prop shaft.Is there somewhere that I can order one that will work with this prop ?model # j150gleue 1997

Thanks Brian


Modified by DUP1014 at 6:24 PM 7/18/2007

[Won Hunglo]

Turn the thrust washer over.

[THE WITCHDOCTOR]

Won't the bevel on the inside of the washer be futher out if you turn it over?

[DUP1014]

I don't think that will work the edge of the raker prop is machined to go on the inside edge of the case so I need the thrust washer to go all the way down.the prop shaft is tapered and the washer is tapered also.I am running a renegade prop
now .
Thanks Brian

[Bassmeister]

The Gade thrust washer won't work on the Raker. You have to have a prop specific washer.

[DUP1014]

Do they make a thrust washer for the raker that will fit my motor ?

[Lockjaw]

Yes you should be able to get one from a dealer, or prop shop.

[Sportwin]

The standard thrust washer that was shipped with your motor fits all Evinrude "V6" hub size props.

The small thrust washer came in the box with the Renegade prop. The Renegade has a "V4 hub size" in order to fit 4 blades. It is the only prop that uses the small hub thrust washer (except a 4 blade Shooter that was discontinued several years back).
If you are using a plastic "weed ring" with the Renegade to fit the V4 size prop hub to the V6 case you will have to remove the weed ring as well before the Raker will fit.

[RUSTY63]

Look at the hub of the Raker you bought, post the part number on the hub under the outer thrust washer, you could have bought a V-4 Raker.

[DUP1014]

Number on raker prop is 394755 14 1/2 x 24 already removed weed ring and the prop fits the shaft .Do not have original prop that came with motor I bought the boat used with the renegade prop already installed.

Thanks Brian

[DUP1014]

ttt