z7 lenght from front of trailer to back of transom.

[blake711]

Can anyone give me the length of a new z7 from the front tip of the trailer or furthest point forward with the swingaway stowed to the furthest part of the transom? If it matters the right side. I know the length with the motor, but need just the length without the motor as my garage is deeper on one side than the other. So the motor will fit but the right side will be closer to a wall.

Thanks.

[BMCD]

Ah geez I did this math when I had a standard garage. I Fit a 911 cdc in a 19x20ft garage.

[LexIS307]

id say figure 25 feet. (i could be wrong) but figure 3 feet for the motor and 2 feet for the front swing away trailer(closed) the nitro site or manuel will have the specs as well/broucher

[blake711]

<table width="90%" cellspacing=0 cellpadding=0 align=center><tr><td>Quote, originally posted by LexIS307 &raquo;</td></tr><tr><td class="quote">id say figure 25 feet. (i could be wrong) but figure 3 feet for the motor and 2 feet for the front swing away trailer(closed) the nitro site or manuel will have the specs as well/broucher</td></tr></table>

That wasn't much of a guess or help. I already knew the nitro site with swing-away tongue says 21'9" package length. Problem I have is I only have 20'6 on my right side of the engine. So I need to know how far back the engine sticks back from the back edge of the boat. Or the furthest point in the front to the back edge of the right side.

[BMCD]

Are you planning to angle it in?

[blake711]

<table width="90%" cellspacing=0 cellpadding=0 align=center><tr><td>Quote, originally posted by BMCD &raquo;</td></tr><tr><td class="quote">Are you planning to angle it in?</td></tr></table> Nope I want it to go strait back in on one side.

[Gambler Bob]

You will have to take the jackplate into consideration if you have one, and even if you dont you should make it big enough if you happen to change your mind in the future.

[blake711]

<table width="90%" cellspacing=0 cellpadding=0 align=center><tr><td>Quote, originally posted by Gambler Bob Rourke &raquo;</td></tr><tr><td class="quote">You will have to take the jackplate into consideration if you have one, and even if you dont you should make it big enough if you happen to change your mind in the future.</td></tr></table> That won't be an issue thanks for the headsup. The garage is deeper on one side than the other. So its basically just the right side of the hull past the engine. I guess I will just have to go to BPS with a tape measure and figure this out myself.

[BMCD]

Then that would be 18' 7"

[blake711]

I asked on the Nitro Facebook account and they said 19'1 in case anyone else needs this info in the future.