Thread: 2200 DC 300 xs

Results 1 to 5 of 5
  1. #1
    Member
    Join Date
    Jun 2010
    Location
    gonzales
    Posts
    296

    2200 DC 300 xs

    I'm getting a 2200 DC with a 300xs with a sportmaster lower with 1.62 gears. The current owner is running a 26 trophy. Wanting to run a Hydro Motive, they have run well on my last 2 gamblers. What pitch Should I run?


    Modified by slicksmith at 2:35 PM 4/3/2011




    2200 DC GAMBLER / 300 XS

  2. Member ldbass55's Avatar
    Join Date
    May 2004
    Location
    Jacksonville Beach, Florida
    Posts
    5,099
    #2

    Re: 2200 DC 300 xs (slicksmith)

    well...i think you are going to be dissapointed with the gears, and especially the sportmaster....for sure on the 2200..but i have been wrong before..if it was me i would sell the lower, for a 1/75 tourqemaster, and send it off to be modified...the sportmaster is designed to run near the surface of the water, and that aint going to happen with the 1650 pound 2200..running 2 to 3 inches below the pad, the nosecone on that lower is like dragging an anchor...
    it may run good enough for you though...the sportmaster, and the g boats just dont go together...and that 300 should be swingin more than a 26 trophy...something aint right there either...
    LD

  3. Member
    Join Date
    Jun 2010
    Location
    gonzales
    Posts
    296
    #3

    Re: 2200 DC 300 xs (slicksmith)

    That's what I was afraid off. With the tourqe master and the proper setup what should I expect out of it.




    2200 DC GAMBLER / 300 XS

  4. Member ldbass55's Avatar
    Join Date
    May 2004
    Location
    Jacksonville Beach, Florida
    Posts
    5,099
    #4

    Re: 2200 DC 300 xs (slicksmith)

    depending on load, the boat should be able to run upper 80's..to be honest...the 300 isnt a whole lot stronger on top end than the 250xs...but it is sure a bad azz looking motor...and has some serious bottom end torque, and midrange...WD has a 2200 that has one of those hopped up rice burners on it... he can probably give you a good starting point on prop pitch, and such...i am sure he will drag in in a few....i think the new razor prop that mark croxton has designed is going to be the prop for the bigger gamblers...but i dont know about how it will work on that sporty...
    LD

  5. Member
    Join Date
    Jun 2010
    Location
    gonzales
    Posts
    296
    #5

    Re: 2200 DC 300 xs (slicksmith)

    Thank You for the help LD.




    2200 DC GAMBLER / 300 XS

Similar Threads

  1. Still Looking For 2200 Butt & rear Seats, and 2200 Cover
    By hotroda10 in forum Gambler Boats
    Replies: 4
    Last Post: 02-19-2010, 10:09 AM
  2. Just what should I know about my 2200 ZR2?
    By Gutshot in forum Gambler Boats
    Replies: 7
    Last Post: 02-18-2010, 04:50 PM
  3. 2200 Set Up Help
    By Fat Basser in forum Gambler Boats
    Replies: 6
    Last Post: 04-29-2009, 08:15 AM
  4. Need some help with a 2200
    By ksoskeeter in forum Gambler Boats
    Replies: 8
    Last Post: 09-03-2006, 11:19 AM
  5. 2200 ? Help
    By Addicted2Bass in forum Gambler Boats
    Replies: 6
    Last Post: 05-09-2006, 02:05 PM