Etec Software and I-Command Digital. Not showing error signals.

[tmuller]

I just purchased the Etec EMM Software and having a blast seeing all the engine data.
One item I cannot get to work.
In the System Check page, none of the test signals; oil low, engine hot, etc. do NOT show on the I-Command Digital Status gauge.

Anyone know if these signals only work with the basic gauges?


PS: I called BRP. They say don't know, don't worry about it. If an alarm does goes off, it "should" show.


Modified by tmuller at 12:27 PM 5/31/2007

[Sportwin]

That feature will only work if you have a "System Check" gauge.

[Greg_Z21]

IMd you.