I have a 1995 intimadator and want to install a live well pump out on it have any of you installed one and is there any thing to the location of the fittings. It always makes me a little nervous to drill holes in my boat. any help would be great thanks.
Been thinking about installing a couple myself, Anybody got some pics we could go by?
Mine had it from factory, the holes are in the back next to the bilge holes.
Noland
"Slower than a speeding Bullet, but faster than a Cookie Cutter."
I have a 95 209TE and put my livewell pump out in 2 years ago. I only put it on the passenger side. I placed it near the bilge outlet. It was tight between the tray and the hull's cap but once I got it on....it's worked like a charm. Boat is in my cellar right now due to the water being too hard to fish in. I'll be heading down there over the weekend and I'll try and get a pic for you. Not easy to get to.
thanks any suggestions would be helpful. it looks kind of tight behind the live well but I think it might work what size pump did you install and where did you mount it? also where did you put the on off switch? thanks again mac I'm trying to do some upgrades on my rig before spring it's in the teens here in Arkansas today but next week it is suppose to be in the 50's if the wind dies down I may get to go out.
I went with the Flow Rite controls. All I did was replace the spray nozzle.Then I drilled a hole in the cap near the bilge outlet. put in their fitting and ran their water line from the spray nozzle to the outlet fitting. When I'm ready to pump out, all I do is reach into the livewell and pull on the nozzle head and it diverts the water out the back. Very simple product and yet very functional.
http://www.flow-rite.com/marine/
Reply With Quote