Champion 190 front bow panel plastic help?

[Champ190]

Heys guys need some help finding the two plastic bow panels that held the troller plug and the front trims switchs. I cannot seem to find them. Mine are getting old and brittle . The boat model is a 1993 190 DCR any help would be great.

[Lea]

http://www.candomarineparts.co....html

Is this what you need? If not, call them to see if they have the ones you need...

[Tx Champ]

My bet is you're not going to find one for a 93 model. But if there is one to be had, C&O will probably have it. They bought all the spares at the Mtn Home plant.

You could also check with some of the ChampioN dealers that were around when the Mtn Home boats were being built. Nichols Marine would be one not too far from you. Pat would know some of the others that have been around a long time. Also some that may have been big champ dealers that currently not carrying Champs.

Good Luck!! If you find more than one, let me know ...

[Champ190]

Struck out with C@O so I am at a deadend so far.

[Lea]

Maybe Mark Miller, Polyfabplastics, a BBC sponsor, can fabricate some for you....417-862-6512

or Del-Mart Molds 623-931-9405. Also a BBC sponsor...

Let us know...it might help others...

[Champ190]

Thanks Lea I will check on and let everbody know if it works.

[Tx Champ]

Here's one more long shot ... these folks built the dash and bow panels for Cobra. Just might be the folks that did the Mtn Home Champs too. I've got some e-mail addresses of a couple of the ex-Mtn Home Champ folks at home. If they are still good, I'll ask and see if anyone knows for sure.

Hodges Marine
Bull Shoals, AR
870-445-4506
Contact Person: Mike or Donnie

[Champ202]

Ill agree with Lea, Give Mark a call I just got some materal from him and remade all my dash panels. A 2 foot by 2foot peace was only like 25 bucks shipped to my door. All I used was a jig saw and a rotozip with a lammit bit worked great.