-
Set up 210?
Got my B&B 27 TXP. Also had a Phase II kit put on my motor. Ran yesterday with me and a buddy of mine on board (540 lbs). I weigh 330. One tank 1/4 full, one tank just below full, all of my gear (50 lbs?). I'm 3/4 in. below the pad. 80.2 gps. 6000 rpms and almost 32 psi on my h2o. And using almost every bit of trim that I have to get those #s. Question is, do I need to go even higher with the motor. If so how much. Do the 210s always use that much trim or will that decrease once I have the motor at the height it needs to be? Had to tie wrap my psi tube on the back of the guage. pressure blew it off at one point. By the way that TXP is a dream to drive compare to the T1. By the way the motor is a 250 HPDI. Thanks for all of your help guys.
-
Re: Set up 210? (jm1495)
The slip numbers are pretty decent for that much weight. I didn't know you had the phase II kit on it?? Lightened up a little, you would need a 28 for that.
-
Re: Set up 210? (GE Blazer)
What about having Mark take some of the cup out and adding some pitch to that 27p that I have know
-
Re: Set up 210? (jm1495)
Don't take any cup out...you may need even more. He can tweak the pitch and you can go higher with the motor with that much water pressure.
Reply With Quote