Greg, I raised the motor up until I began to loose lift, still had good H2O pressure but still can't get but 5700 loaded,5800empty? ordered 4inch setbacks friday! I posted a message to Mark about it! Do you think the extra setback will help? Thank's Wayne.
PORKFORG, WHAT BOAT , MOTOR AND PROP ARE YOU RUNNING? YOU ASKED ME ABOUT MY 202 ,250HPDI AND TXP 27. WHAT KIND OF NUMBERS ARE YOU GETTING ON YOUR SETUP? THANKS JASON!
Jason, I'm turning a 29T1 on a 300HPDI, it's on a 202! I've had makr b/b the prop! before it wasn't turning but 5600 when I got it back I got 5700 loaded & 5800 empty! Greg said I need either a 15inch rapidjack, I'm gonna add 4 inch setbacks!
SOUNDS GREAT , ARE RUNNING IN UPPER 80'S OR 90 RANGE ? I JUST GOT MOTOR BROKE IN AND STARTED ON THE MOTOR HEIGHT. TURNING TXP 27 AT 5800 RPMS GPS OF 82. I RAN MOTOR HEIGHT OF 1/2 BELOW TO EVEN PAD WITH ABOUT THE SAME RESULTS.
Look all you need is more setback I bought my new 250 hpdi and had a Bob 10'' Hd had the same problem best speed was 74 gps I was p.o took a little reading and found out that most guy's were running a 15" rapid jack bought it end of story 82 gps go figure . I don't claim to know as much as some of these guys but some of them are pretty sharp but the bigger the motor the more set back you need on a 202. don't waste your time with spacer go with the rapid jack then get Ge to set you up with a good prop good luck
Fear-This
2000 202 pro v / 04 250 Hpdi 27 T1 Work
15" Rapid jack 1 1/2 inch below Pad
Tourney Loaded Wot 80.6 gps
Light 83.9 gps
The setback will help with the bowlift. You may lose a little holeshot though. A good rule of thumb is for every inch you go back, you can raise the engine a 1/4".
Yep I did lose hole shot , but for the speed gain it was well worth it .
Fear-This
2000 202 pro v / 04 250 Hpdi 27 T1 Work
15" Rapid jack 1 1/2 inch below Pad
Tourney Loaded Wot 80.6 gps
Light 83.9 gps
You'll gain your holeshot back with a foil from Bman and skidplate.
Chad St. Pierre
Paulina LA 70763
when it's running 5800 rmp empty it's running 85.
i've got a guy that's gonna make me a hole shot plate.
GE,this dam# computer has been on the fritz for two day's so I couldn't receive IM's would you e-mail me at waynemoon1@yahoo.com
Reply With Quote
