Results 1 to 5 of 5
  1. #1
    Member fishhooked's Avatar
    Join Date
    Aug 2004
    Location
    North East
    Posts
    240

    1971 evinrude 60hp

    Need a little help this engine idles bad. loads up or misses on takeoff but runs good once underway. carbs were cleaned
    there isnt as much vacuume on the two lower cylinders as the top with the bottom being the worst compression is 130 on all cylinders.




    Phil Simmons

  2. Member fishhooked's Avatar
    Join Date
    Aug 2004
    Location
    North East
    Posts
    240
    #2

    Re: 1971 evinrude 60hp (StratosRocks)

    b


    Phil Simmons

  3. SC Club Moderator ChampioNman's Avatar
    Join Date
    May 2004
    Location
    Crawfordville, FL/Lake Hartwell, SC
    Posts
    72,119
    #3

    Re: 1971 evinrude 60hp (StratosRocks)

    Checked the fuel pump for any leaks?

  4. Member fishhooked's Avatar
    Join Date
    Aug 2004
    Location
    North East
    Posts
    240
    #4

    Re: 1971 evinrude 60hp (ChampioNman)

    I willl check for an internal leak there is no external leak.



    Phil Simmons

  5. Member fishhooked's Avatar
    Join Date
    Aug 2004
    Location
    North East
    Posts
    240
    #5

    Re: 1971 evinrude 60hp (StratosRocks)

    also would the charging system cause a problem like this.
    doese it need more than 12volts at idle



    Phil Simmons

Similar Threads

  1. Please Help on 1994 Evinrude 60hp
    By jamenji84 in forum Evinrude/Johnson Motors
    Replies: 0
    Last Post: 08-29-2009, 04:01 PM
  2. Evinrude OMC Genealogy - 1961 > 1971
    By LIQUID NIRVANA in forum Evinrude/Johnson Motors
    Replies: 0
    Last Post: 05-04-2009, 07:41 AM
  3. 1971 evinrude 85hp clipper assy?
    By nicho270 in forum Evinrude/Johnson Motors
    Replies: 15
    Last Post: 08-05-2006, 08:26 PM
  4. 1971 85hp Evinrude...more problems
    By nicho270 in forum Evinrude/Johnson Motors
    Replies: 4
    Last Post: 07-09-2006, 08:51 AM
  5. 1971 Evinrude 85 hp
    By nicho270 in forum Evinrude/Johnson Motors
    Replies: 3
    Last Post: 06-22-2006, 04:41 PM