I-Command gauge defaults to RPM screen

[Barks]

I've got one 3" guage and two 2" guages for my 115 E-Tec.

Each time the gauges are turned on, one of the 2" ones displays the RPM page then reverts back to the chosen page.

Even if I remove the RPM page altogether from the gauge, it still appears at start-up.

It also appears each time you give the engine some revs and then reverts to the page that is set.

I've tried reseting the timeout function but no luck.

Any suggestions would be appreciated before I try to a factory reset.

Thanks

Barks

[SEAHORSE]

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Barks &raquo;</TD></TR><TR><TD CLASS="quote">

It also appears each time you give the engine some revs and then reverts to the page that is set.
</TD></TR></TABLE>


It sounds like the tach is programmed in the "pop up" mode. Read the instruction manual on how to set and reset that feature.

[Barks]

Thanks Seahorse.

Pop ups aren't listed in the LMF-200 manual, but found it within the Pages menu.

Cheers,

Barks