SHO 250 connecting to Command Link

[mathews2000]

I am wanting to connect my new SHO to my HD8 (NMEA network). I know there are a lot of topics here about that but....

So..

Connecting the Command Link Hub to my SHO.
I am not have much luck finding where to connect the cable (to the motor). I found a connector on the SHO that looks right but it only has 2 wires going to it (white connector). It is located on the passenger side and nothing is connected to it. I am thinking that it is for the service PC to connect (just guessing).

Does anyone have a picture or know where I need to connect to on the 250 SHO?


Next any good way to run cable from my Ranger(2011 Z521) to the SHO?

Just to make sure- Do I need to add the Command link hub in order to connect the SHO to the HD8s (NMEA network)? I only have analog gauges at this time.

I already have the cable that Lowrance has to connect the NMEA network (part number 120-37) to the Yamaha. Can this be connected directly to the SHO or does it need to be connected via Command Link Hub?

[Z521SHO]

Mathews 2000
I have the set up working on my 2010 z-521 with SHO. It should plug into your Structure Scan box and then you can get your digital gauge reading. I will check mine for sure and let you know.