My trim seems to operate fine will in open water but when I give it that final punch to load on the trailor I noticed it droopped while doing this and messed up my prop. Any ideas on what is going wrong and what to check? Also can I check the trim fluid level with the motor in any position?
Thanks in advance
98 200 ox66
98 ZX202c 200 Yamaha VMAX
Trim the engine all of the way up, then flip down the engine support. SLOWLY, unscrew the trim fluid cap, be careful, sometimes it can build up some pressure. The trim fluid should be totally full.
thanks for your response. I did that and fluid was comng out so I know thats not the issue. Im scratching my head now even more.
98 ZX202c 200 Yamaha VMAX
You have a bad seal somewhere. Some of these guys on here have rebuilt their trim units, so I'm sure one of them will come along and give you some better answers.
98 ZX202c 200 Yamaha VMAX
Reply With Quote