Results 1 to 3 of 3
  1. 05-21-2009, 11:54 AM #1
    skeeterss
    skeeterss is offline
    Member
    Join Date
    May 2006
    Location
    centreville
    Posts
    69

    yamaha air duct molding

    just wandering if a hpdi silver air duct molding on the top rear of the engine would fit on a vmax carb. 150, or if there is a after market one available that is like the silver hpdi air duct. I like the look of the longer air duct.
    [IMG][/IMG]
    Reply With Quote Reply With Quote
  2. BuzzB8
    BuzzB8 is offline
    NC Bass Club/Yamaha Motors Moderator BuzzB8's Avatar
    Join Date
    Jun 2004
    Location
    Asheboro, NC
    Posts
    7,090
    #2 05-23-2009, 12:30 AM

    Re: yamaha air duct molding (skeeterss)

    Hmmm, I never thought about it.
    Reply With Quote Reply With Quote
  3. fishin couillon
    fishin couillon is offline
    Lowrance/Garmin/GPS Moderator fishin couillon's Avatar
    Join Date
    Jun 2004
    Location
    Pineville, La
    Posts
    34,299
    #3 05-23-2009, 07:57 AM

    Re: yamaha air duct molding (BuzzB8)

    It would look pretty cool.
    YOU are not entitled to what I have earned!!!!!

    2014 Phoenix 619 Pro / 2014 Mercury 200 Pro XS
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Molding
    By Triton Basser in forum Gambler Boats
    Replies: 2
    Last Post: 02-14-2011, 04:22 PM
  2. Looking for top cap (air duct molding) for HPDI cowling.
    By John Hagins in forum Yamaha Motors
    Replies: 1
    Last Post: 08-22-2010, 08:05 AM
  3. Molding
    By BARRY J in forum Bassboat Restoration
    Replies: 2
    Last Post: 08-10-2008, 07:21 PM
  4. cowling air duct loose
    By Chevy II in forum Yamaha Motors
    Replies: 0
    Last Post: 06-24-2008, 07:23 PM
  5. 200XL down again... another use for duct tape...
    By capticeman in forum Stratos/Javelin Boats
    Replies: 20
    Last Post: 09-25-2006, 06:40 AM