would like to thank everyone for the great info, I was experiencing low water pressure on my 07 225. removed the poppet valve and there was some large grains of sand keeping it open. not the easiest thing to get to. thanks again
Steve
would like to thank everyone for the great info, I was experiencing low water pressure on my 07 225. removed the poppet valve and there was some large grains of sand keeping it open. not the easiest thing to get to. thanks again
Steve
Too bad you did not put in the new mushroom style that prevents future clogging... I did it as well. Tough job for one person. Maybe yours already had that one in it?
Marks Props 317-398-9294, 1850 East 225 South, Shelbyville, Indiana 46176 propellerman59@gmail.com http://www.marksprops.com/index.html
2007's should have the newer mushroom style valve. I remember when I updated mine and replaced the gasket, that was not easy to do.
2013 Skeeter MX1825 with Yammy F150 & Garmin Ultra 106sv & LVS34 Livescope
"My hotfoot pedal goes to 11"
The hardest part is getting the gasket and cover back on. Not a lot of room and gasket will keep falling when trying to push the screws through. All in all though it was only a one hour job for me.
It took me about an hour with my fat fingers, it looked like the valve was the newer mushroom style. luckly the gasket stayed in place and did not tear.
where is this poppet valve located at on my 04 250 HPDI? I may need to check mine.
What was your pressure before cleaning the poppet?
08 Ranger Reata 210
Yamaha VMAX 225 HPDI
Brad,
It's the top one on this page. Pictures and instructions. Check it out as I'm sure it will be a big help. Here's the link:
http://www.bbcboards.net...85398
My pressure is fine. I was just curious what his pressure looked like prior to the install.
08 Ranger Reata 210
Yamaha VMAX 225 HPDI
Reply With Quote
.jpg)
