I have a 1995, 150 hp Evinrude motor and I seem to have lost the proper trim on my gauge. I would like to correct this if possible without getting my mechcanic involved! Plus Im kinda getting tired of looking back to see if im trimmed properly! Thanks as always for any help!!!
The trim sender is adjustable at the motor.
Could you be just a little bit more specific? Where?, What?, Right ,Left......... Thanxxx!
Tilt the motor, look inside the port side motor bracket, trim sender is mounted with two bolts, loosen the bolts, twist the sender one way or the other, tighten the bolts and check.
Reply With Quote