Pro Xs Decal Help Needed

[panteraII]

re-decaling the cowl on my 3L and need help.

can someone take a few measurements ?? Please

I need the measurement from the bottom of the cowl to the lowest point at the bottom of the side Pro XS decals, Same measurement needed for the front and rear decals. I also need from the back of the cowl to the "S" in XS. Some good cowl pics wouldn't hurt either since beggars can beg for whatever they want.....



Seriously all help will be greatly appreciated as I want my decals to be correctly located.

Thanks.

[kllr bee]

Don't know measurements but I can tell you this. When installing decals use a soapy water solution and you can move the stickers around and get air bubles out then let them dry for awhile. They WILL stay stuck and make for a easier install.
Richard

[EuropeanAM]

Anyone got some pictures? Not a single one in the shop at the moment....

[Flipping57]

[panteraII]

thanks for the quick response.that helps... Still looking for some up close pics and/or some measurements. I am abasolutely anal when it comes to doing things exact. Most times I exceed the factory's care and attention to detail.

[Bass Commander]

[SNUFFY]

Using the red and grey line in the stripe under the letters ProXS......at the rearend where the red and grey meet is 2 1/16......the front end is 1 15/16 where the red stops and the grey starts. these are the side decals
The back is 4 1/2 " the left bottom corner of the "P" in the Pro
These measurments are from the sharp square bottom edge of cowl on 225 09 ProXS

[ALF1]

Talk to Iguana and have him do the same decals in different colors. Something to match your boat.

[panteraII]

This is exactly what I needed. THANKS FOR YOUR TIME AND HELP !!!!


Since I am imposing


What about a front to back measurement for the sides ? and the front decal ?