easy loader trailer bearing size

[ZXD]

I have a ez loader 2002 tandem trailer under my skeeter, Does any one know the size of these bearings, so i could keep a spare set in my toolbox?


Modified by ZXD at 8:26 PM 1/6/2009

[LarryBarker]

Your trailer should have EU-37 trailer bearing hubs manufactured by the UFP corporation. You can get the exact size of the bearings off their website. It's http://www.ufpnet.com. Or you can use the following part numbers.

Inner Bearing-L68149
Inner Race-L68110
Outer Bearing-L44649
Outer Race-L44610

The seal is going to be the tricky one. In May of 2002, UFP increased the outer diameter of the seal. Here's the two possible ID/OD of the seals. You should be able to check this pretty quick on the trailer.

Hope this helps,
Larry Barker
EZ Loader Custom Divison
Possible Diameters (OD/ID):
Before May 2002: 2.33" x 1.68"
After May 2002: 2.56" x 1.68"

[ZXD]

Thanks a lot, larry