Results 1 to 2 of 2
  1. #1
    Member
    Join Date
    Aug 2006
    Location
    Fredericksburg
    Posts
    51

    Cold start troubles 0n 1988 200XP

    Have to start with shift lever advanced (fast idle) now. I used to be able to push in key for prime and it would start. Also have a very sporadic problem with the motor bogging on initial full throttle to get going. When this happens, I drop it back in neutral and try again. Once it takes off, motor runs fine the rest of the day. Any thoughts would be appreciated.

  2. Member
    Join Date
    Apr 2007
    Location
    Fort Worth, TX
    Posts
    502
    #2

    Re: Cold start troubles 0n 1988 200XP (201proride)

    Check the Primer Solenoid for leaking and actuation. It's below the VRO and has a red lever protruding from it. Pushing-in on the key sends a signal to this solenoid and it primes the carbs.

    2017 Ranger Z520C / Mercury 250 ProXS 2S

Similar Threads

  1. 1988 Evinrude 200 XP - Won't shift to reverse cold...
    By Eric - Bass OH in forum Evinrude/Johnson Motors
    Replies: 2
    Last Post: 08-13-2009, 06:03 PM
  2. 200XP died and won't start
    By ta3834bbl in forum Evinrude/Johnson Motors
    Replies: 13
    Last Post: 07-16-2008, 01:03 PM
  3. Hard to start 1988 200XP
    By 201proride in forum Evinrude/Johnson Motors
    Replies: 6
    Last Post: 07-12-2007, 08:33 AM
  4. Cold Start OK ~ Hard Warm Start
    By Rmax in forum Yamaha Motors
    Replies: 2
    Last Post: 05-17-2007, 05:32 AM
  5. Prop diameter for a 200xp 1988
    By 201proride in forum Evinrude/Johnson Motors
    Replies: 5
    Last Post: 12-30-2006, 02:43 PM