have a 05 225 etec that will only get 5100 rpms, hooked to computer and showed no codes, all injecteors were replaced under warrenty 2yrs ago for wrong spray pattern,run good gas, all plugs firing, anyone have any ideas why this is happening
have a 05 225 etec that will only get 5100 rpms, hooked to computer and showed no codes, all injecteors were replaced under warrenty 2yrs ago for wrong spray pattern,run good gas, all plugs firing, anyone have any ideas why this is happening
What hull, what prop, what is the prop to pad measurement?????
ranger Z 20, 26 RAKER, boat ran fine last season 5600rpm gps at 71.6mph, it ran bad to start this season then sunday kicked in and was running normally, monday halfway across lake bogged back down and would only get 5100rpms again,hooked to computer today showed no codes, place i took it to said without it showing a code for a malfunction they had no idea,also boat will take forever to get on plane and pretty much wont if 2 people in boat, plugged injector?, would this show on codes, anyway to backflush a etec
Modified by semperesox at 3:24 PM 6/3/2010
Could be a plugged injector, it will not set a code! Did they do a compression check?
Dan Burnette - Marietta, GA
Triton 18TRX - 200 HO G2
no they did not do a compression check
hmmm...let me guess again...INJECTOR.
Compression test and a cylinder drop test should have been performed first thing.
-----
A Technical troubleshooter possessing more tools than talent !
Reply With Quote
