Results 1 to 3 of 3
  1. #1
    Member
    Join Date
    Jan 2007
    Location
    Nampa, ID
    Posts
    1,393

    WOT cutting out/Sensor in air dam

    My 07 E-Tec 150 is cutting out at WOT. It will bog down and the take off, bog down and then take off. The difference is about 300 RPM. I thought maybe it was the fuel bulb, but it seems fine. I took the couling off this evening and found that the sensor that goes into the air dam had fallen out. I assume it is some sort of oxygen sensor. Would that cause this behavior?

    Thanks
    Tom


    Modified by joevandal95 at 8:07 PM 3/17/2010
    2013 Nitro Z8
    2013 Mercury 250 Pro XS

  2. Member
    Join Date
    Jan 2007
    Location
    Nampa, ID
    Posts
    1,393
    #2

    Re: WOT cutting out/Sensor in air dam (joevandal95)

    bump
    2013 Nitro Z8
    2013 Mercury 250 Pro XS

  3. SC Club Moderator ChampioNman's Avatar
    Join Date
    May 2004
    Location
    Crawfordville, FL/Lake Hartwell, SC
    Posts
    72,179
    #3

    Re: WOT cutting out/Sensor in air dam (joevandal95)

    I'd take it to my local dealer for a check out. Let them put the computer on it and verify any issues.

Similar Threads

  1. Fuel line/bulb/pulse fuel pump
    By abianca99 in forum Mercury - 3 Liter & 3 Liter High Performance
    Replies: 8
    Last Post: 03-24-2012, 01:49 PM
  2. VMAX 150 Fuel Line/Primer Bulb question
    By mmunroe27 in forum Yamaha Motors
    Replies: 0
    Last Post: 06-13-2011, 08:08 AM
  3. Replaced fuel line, now no hard bulb???
    By HDETERS in forum Mercury - 3 Liter & 3 Liter High Performance
    Replies: 7
    Last Post: 03-06-2010, 08:14 AM
  4. Ethanol resistant fuel line and fuel bulb question
    By blurry in forum Mercury - 3 Liter & 3 Liter High Performance
    Replies: 1
    Last Post: 12-14-2009, 01:30 AM
  5. BRP Fuel line/primer bulb for E-TEC 200
    By andygere in forum Evinrude/Johnson Motors
    Replies: 3
    Last Post: 05-20-2006, 12:02 AM