This 88 is a long shaft. It has a spacer between the mid-section and gear case. I am wanting to make it a 20inch shaft. All I think I will need is a new upper drive shaft and shift shaft. Please help me out and let me know if I am wrong or right?
Thanks,
New drive shaft, new shift rod, the exhaust tuner and the mid section. Let me know as I have parts to do this but shipping will cost as I am in Canada.
2004 Gambler Outlaw
2000 200HP Evinrude Fitch
73.5 mph so far and climbing
How much for the parts? I won't need the midsection. This motor has a 20inch midsection that has a spacer between it and the gearcase.
Please read rule one, if you would post your model and serial number we can assist you better in your case the serial number isn't mandatory. thanks the mgmnt
The E88TSLEOC is a 20" motor, the XE88TSLEOC is the 25" motor.
I know. The motor was extended at the dealership with a spacer plate for the boat it was being put on
OK now we got that out of the way, you'll need to remove the spacer, get a 20" drive shaft, shift rod and an exhaust shoe to fit between the tuner and LU.
I now have the driveshaft and shift rod taken care of. All I need now is the 20inch water tube and the exhaust. When I look at the parts diagram, it shows two for the exhaust . The exhaust housing inner upper and the exhaust housing inner lower. Do I just need the lower to finish?
Yep that'll do it 327796 for the exhaust housing and 323403 for the tube both for 20" shaft models.
Reply With Quote