Tried a couple of jointed baits yesterday. Painted them while they hung vertically. The painting wasn't really all that hard. Getting them on the drying wheel was a pain though.
A BBZ Shad. The white spots by the joints are from the flash on the camera.
[img][/img]
A Strike King King Shad
[img][/img]
A Tru Tungsten Shad
[img][/img]
Cheaper to keep a kid in tourney fishing than paying attorneys to keep them out of jail !!
Mesmerize Jigs.Performance Team Rods, Just add water bait and tackle
Those are sweet. Great job, Moose.
Chris Dunn...Dallas, Ga.
2006 Blazer 202 / Yamaha 250hpdi
'97 ProCraft 180DC
Dale Johnston
Wichita, KS
2019 nitro z20, mercury pro xs 250 four stroke
Steve
2006 Sylvan Expedition Sport
2006 Yamaha F150 TXR s/n 63P L 1041829
How did you manage to turn the Spro bait? Have some big balsa wake baits truning now (single, mid-body joint) and managed that easily enough with some wire and cable ties at line tie and rear hanger. Have not been able to figure how to stretch the Spro out like that.
Nicely done.
I actually just did a few wraps of thin wire around the joints and they held very well.
Reply With Quote
