ned help with my '06 E-tec 115

[ehailstone]

I have an '06 E-tec 115 that I recently got back from the dealer with a new power head. The first threw a connecting rod and we drifted to shore, stored the boat and sent the motor off.
Got the rebuilt motor this summer, and put it on the boat, went 10 miles to test it, then went to our Salmon camp, a 40 mile r/t from this village.
On the way back the motor stopped. We got it going again in the Safe mode and made it to shore. The ocean wasnt at its best and it took us a couple days to get back to this village.
I was thinking it was a bit of water in the system, but I couldnt find any. I put hose clamps on the motor mounted fuel filter because there were small bubbles , and I know that could be trouble, and my gas is clean.... (I also have Racors on the boat, fuel lines running through them)
it starts and idles just fine, one twist of the key, but it wont excellerate.
Thes only light on the brainbox is the third one, Sensor/Fault.
Im 140 miles from home, all my $is in gas and the motors r/t to the dealer and back is a bit over 1,800$ in shipping again. (this is the Arctic)My warrenty is good untill Nov this year, but if it gos to the dealer, Im sunk for another summer.

What is the cylender with air hose valves on the fuel pump??

If I had any water in the fuel, how would I go about ridding it? I dont want to open the fuel lines if I dont have to, but I will do anything to get home.

I NEED help!
Can I fix it myself or should I just abondon it?
everybody here has carburated engines so we can fix them ourselfs, so theres little help around.

Thank you,

Hailstone

[SEAHORSE]

What is the model and serial number?

I think the 115 E-TEC did not come out until 2007.