Results 1 to 3 of 3
  1. 06-21-2009, 11:39 PM #1
    Everrude
    Everrude is offline
    Member
    Join Date
    Jun 2009
    Location
    Syracuse
    Posts
    5

    Any info on '84 Evinrude 150xp V6 (cross port or cross flow) pre ficht

    looking for proper setup info and general info on reliability or any issues with that model....Thanx
    Reply With Quote Reply With Quote
  2. ChampioNman
    ChampioNman is offline
    SC Club Moderator ChampioNman's Avatar
    Join Date
    May 2004
    Location
    Crawfordville, FL/Lake Hartwell, SC
    Posts
    72,144
    #2 06-22-2009, 04:31 AM

    Re: Any info on '84 Evinrude 150xp V6 (cross port or cr ... (Everrude)

    Solid 90* motor no major issues.
    Reply With Quote Reply With Quote
  3. DoferGofer
    DoferGofer is offline
    Member DoferGofer's Avatar
    Join Date
    Jun 2004
    Location
    Edgewood Maryland
    Posts
    1,807
    #3 06-22-2009, 05:11 AM

    Re: Any info on '84 Evinrude 150xp V6 (ChampioNman)



    Other than being a mama sow gas hog. Solid to the bone.

    Had mine since 1985.


    If you can't run with the big dogs, just stay on the porch.

    Model E150DPLIIB, Serial 05311818, Mfg Date 02/2011
    SST... 14 1/2" x 19" 45.0 mph.@4950
    Rebel 15 1/2" x 17" 45.1 mph.@5250
    Rebel 15 1/2" x 16" 44.6 mph.@5300 (Re-pitched/Balanced/Blue Printed by Mark's Props)
    Rebel 15 3/4" x 15" 44.2 mph.@5700-5750
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. cross flow/ fast trac trim units
    By buck75 in forum Evinrude/Johnson Motors
    Replies: 1
    Last Post: 09-19-2007, 06:23 PM
  2. Looper to Cross-flow Question
    By tlucas1972 in forum Evinrude/Johnson Motors
    Replies: 18
    Last Post: 08-07-2007, 06:19 PM
  3. Spark plug torque on a Cross-Flow Critical or not?
    By DoferGofer in forum Evinrude/Johnson Motors
    Replies: 10
    Last Post: 07-07-2005, 04:02 AM
  4. Head for 235 Evinrude or cross refeerence to same head
    By jglenn in forum Evinrude/Johnson Motors
    Replies: 3
    Last Post: 04-18-2005, 04:06 PM