Need a little a knowledge from y’all.

[masonadaddoo]

I am looking to replace and reseal the bow eye and transom eyes. Also need to reseal my jack plate bolts. What is the sealant needed for each of the jobs. I had this info somewhere and cannot find it for the life of me.
Thanks, Jason

[Sleepy111]

Either of these will do great, 3M is prob the most recommended. You can get the 3M in white or black if you wanted it to really match your hull. Clear is just fine though.

https://www.basspro.com/shop/en/boat...E&gclsrc=aw.ds


https://www.basspro.com/shop/en/3m-m...5200-for-boats

[bigbass56]

I all ways use 3 m. 5200 not cheap but works very well

[WVBullet]

3M definitely

[masonadaddoo]

Thanks guys the 3m 5200 it is. I couldn’t for the life of me remember which ones to use.

What is the Bullet recommended torque spec. for the jack plate bolts? I really appreciate the help, Jason

[crank68]

I would rethink using 5200 for my jackplate bolts….wayyyy to permanent. We try to remove a lot of components, such as jack plates and engine brackets that have been installed and/or sealed with 5200.

[21XDC]

4200 might be the better option...