I could use some suggestions. I had #2 cylinder resleeved by Marfab. The engine went back together well but after over 14 hours of electrical diagnostics,a new power pack and new coils on #2 and#6 we have no spark on those new cylinders. Please relay ant tips you may have to get me back on the water. Thanks
Check the wires on the coils orange blue trace goes to top coil, orange green trace to bottom coil. Also make sure timer base connectors are tight and check the stator connector leads to make sure you don't have a pushed pin.
Are you checking the spark with a spark board or are you trying to run the engine?
Thanks for your inquiry We are cranking the engine testing each cylinder with a spark indicator inline attached to the spark plug Thanks again look forward to your reply
Reply With Quote