The motor seems to move side to side way too easily (by hand). I've been using the trolling motor since I noticed this problem, so I don't know if it has an effect on the steering at speed. Is it possible that something is loose in the steering even though the wheel is tight and seemingly responsive? I don't really know where to start looking, so any input would be appreciated. Also, it doesn't trim up while underway, only at idle. Do I have to replace the trim motor?
Sounds like you may have a bad upper motor mount.
Does the trim raise, but the motor stay down?
_________________________________________
96 Javelin 379SE 96 Johnson 150 (J150ELEDB)
Mods: FS carbs, Ficht reed cages, boyesen reeds and
Baker Hot Heads.
My 91 150 had some side to side and I tightend the nut on the pivot tube and it took care of it!! just my 2 cents!! Jason
<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by Crankenstein »</TD></TR><TR><TD CLASS="quote">My 91 150 had some side to side and I tightend the nut on the pivot tube and it took care of it!! just my 2 cents!! Jason</TD></TR></TABLE>
yep mine was doin the same thing,looke like i had real problem,tighten the big nut per championmanand it don't wiggle at all..
Thanks a lot, I'll try tightening that nut. As for the trim, the motor will trim up as normal, but only when the boat is sitting still. Any pressure on it and it stays down.
Reply With Quote