Wiring - ZX200

[pwats]

This might sound like a dumb question, but does anyone have a picture of the of their battery compartment/battery wiring for a ZX? I bought my boat last year and when I went to get it winterized they disconnected all the batteries before I could label the wires or take a picture. Boat is '07 ZX200 w 200 HPDI, 3 batteries.
Thanks

[fishnmd]

No pix. but I recently cleaned up the compartment, on 2008 zx 200. You should have a wiring harness that goes to motor, eg 2 ga, that goes to single battery on starboard side. If you have onboard battery charger that obviously also attaches with that harness. The two batteries on port side have their respective charger connections and the trolling motor connections. If you have a 24 volt TM then a jumper goes from 1 neg to the other pos. Tm connects to one Neg an the other positive

[pwats]

Thanks for that. It was the jumper wire that I wasn't 100 % sure about.

[dr. seuss]

just replaced my batteries yesturday and that was the right advice given