How do I tighten up my reat seat mount?
How do I tighten up my reat seat mount?
Search the Skeeter threads, I believe this was asked before. Is there anyway to get at the bolts from the rigging area?
2013 Skeeter MX1825 with Yammy F150 & Garmin Ultra 106sv & LVS34 Livescope
"My hotfoot pedal goes to 11"
Reach forward from the gas tank area and you should find four little holes with four bolts sticking thru with four nuts and washers. Getting the little buggers to not turn while you are tightening them is the pain.
You sure the bolts aren't broken ,just loose? A couple of mine broke off.Went to Home Depot and got some longer ones along with some lock nuts.You'll need the longer one to get the nut started cause those holes where the bolt comes out is a tight fit.Once the nut starts use a regular screwdriver to run it up.
yep same thing happened to my 2001 zx225, two bolts actually broke, what el sketer said, is what i had done on my old boat, youll have to make small cuts in top of carpet to access the top side of bolt , but good qaulity adheivsive such as 3m products used and youll never know the cuts were made
Unable to locate previous posts, as I have seen them too. Some even had pics.
ANyone out there have a link????
Reply With Quote