Thread: Any one need?

Results 1 to 6 of 6
  1. #1
    Moderator
    Join Date
    Dec 2004
    Location
    Jim Thorpe PA.
    Posts
    3,566

    Any one need?

    just have one. 25.00 plus shipping
    Vince Dart- Jim Thorpe PA

  2. Member
    Join Date
    Feb 2010
    Location
    Thunder Bay
    Posts
    23
    #2

    Re: Any one need? (dartman)

    I have one thats slower (or faster depending on how you look at it) than the other. It makes my 2200 roll over slightly until they both reach the end of their travel.

    If this will fit my 02 2200 and you can take paypal..I'll take it! I have a Minnesota address to use so there's no cross border nonsense involved for you, since I live in Canada.

    I guess the interesting part will be determining which one to change out?


  3. Moderator
    Join Date
    Dec 2004
    Location
    Jim Thorpe PA.
    Posts
    3,566
    #3

    Re: Any one need? (Gutshot)

    It's yours if you want it. send me your addy trsure@ptd.net
    Vince Dart- Jim Thorpe PA

  4. Banned
    Join Date
    Oct 2009
    Location
    Staunton, VA
    Posts
    11,604
    #4

    Re: Any one need? (Gutshot)

    Gutshot... take out the one that is moving slower. I had the same problem with my 2100. I just replaced the one that was coming out slower, and it fixed all the problems...

  5. Member
    Join Date
    Feb 2010
    Location
    Thunder Bay
    Posts
    23
    #5

    Re: Any one need? (ThunderCat)

    Thanks very much for the advice ThunderCat. That will be how I approach it.

    I was internet-less there for a couple of days (due to some over-zealous guy with a backhoe) and out in the bush for a few more, so I apologize in my delay in replying to this thread. I hope that didnt cause any problems for anyone.

    Its kinda odd when I come in for a landing with the trim tabs, and the boat rolls over a good bit. Its not as noticeable when coming out of the hole as it is dropping back into the water.

    It'll be nice to have it normal again.

    Thanks,


  6. Member
    Join Date
    Aug 2009
    Posts
    1,519
    #6

    Re: Any one need? (Gutshot)

    You could put them on seperate switches and just delay a little on the fast one. I have them same problem and thats what i plan to do to resolve it instead of spending $200plus for a new one