I-Command Digital Install?

[kamie]

I am running the wiring for an E-Tech 175 with I-Command digital gauges. The install manual for PN 763544 says to attach the purple wire to the Power supply harness red wire. Exactly where is that? On the power supply side, I can't find an open wire anywhere? The purple wire also already has a connector on it?

On the control side, i have the open purple and black wires to match to the red and black of the PN 763678, so no issues there.

And just to answer the ultimate question, I ordered the install manual last week, but it won't ship until this week. So I did try.

Thanks for any help.
--kamie


Modified by kamie at 2:50 PM 5/21/2007

[tmuller]

What part is #763544? That doesn't show to be part of I-command Digital.
Usually the purple is for the acc. (on) on the ignition side. That way you power up the gauges when the key is turned on.

[kamie]

It is the Tilt and Trim harness.